FEHLING FAT DRAG BARS FOR ONE INCH DIAMETER HANDLEBAR CLAMPS
AMERICAN MADE 1 1/4 INCH PHAT DRAG BARS
Made in Germany handlebars for 1970 and later Harley-Davidsons except XG Street models. Take standard and aftermarket Harley-Davidson handlebar controls and risers designed for 1" handlebars and a one-piece, 4-hole riser top clamp. Install on Springer models with a Rebuffini Taurus upper fork clamp. Not suitable for electronic Throttle-By-Wire.
Recommended Retail Prices include 25.00% sales tax.
Prices exclude shipping, import duties and installation.
Prices are based on EUR to NOK interbank rates obtained daily. The interbank rate is the rate that banks trade currency to each other. These prices must be used as a guide.
B. End Rise
D. Center Width
E. Base Width
F. Pull Back
G. Knurl (center-to-center)
C. Dimples & Slotted
•Dimpled handlebars have indents at the handlebar controls to route the switch wiring
•3-Hole handlebars allow routing of the switch wiring through the handlebars. Wiring exits in the mid lower part of the handlebars
•4-Hole handlebars allow routing of the switch wiring through the handlebars and "Hidden Wire" risers such as ZPN731590, 731591 or 731592
Note: ZPN090012 Adapter spacer for cable throttle on TBW bars.